Recommended 4S LiPo Range (Electric Builds)
A well-balanced setup for the Nexa Bf-109 is a 4S 14.8V 4500–5000mAh pack. This capacity range typically supports 6–10 minutes of scale flight while keeping the airplane within the published CG window. For stronger punch and reduced voltage sag during extended climbs, consider higher discharge ratings.
- Balanced pick: 4S 5000mAh 65–70C (XT90/EC5)
- Performance pick: 4S 5000–5200mAh 70–90C (EC5 preferred for higher current)
- Endurance pick: 4S 5200mAh (verify CG and all-up weight)
Explore more options in our 4S LiPo Battery Collection for RC airplane.
Receiver Power (Nitro/Gas Builds)
If you’re running a glow or gas engine with a dedicated receiver supply, choose a 2S LiFe 6.6V receiver pack for stable voltage and reliable brownout resistance.
- Typical range: 2S LiFe 2100–3000mAh
- Connector options: XT60/EC3 for charge/lead, JST/JR/Futaba for RX switch harness
See compatible packs in our LiFe Receiver Batteries Collection.
Connectors & Wiring Notes
Match the pack connector to your ESC or adapt using a short, low-resistance lead. XT90 is common for moderate current; EC5 provides more contact area for higher-draw setups. Keep leads short and secure to reduce voltage drop and minimize wear at the firewall/battery tray.
Flight Time & CG Considerations
Reported test flights on 4S ~3600mAh show ~6.5 minutes to storage voltage. Stepping up to 4500–5000mAh extends time while maintaining handling. After any battery change, re-confirm the CG at 88–92mm from the wing root leading edge and verify elevator trim on the maiden.
Setup Guides & Flying Tips
Crosswind takeoffs benefit from proactive rudder management due to the narrow undercarriage. For scale aerobatics—loops, rolls, inverted passes—higher C-rating packs keep throttle response crisp throughout the routine. For detailed flying impressions, read our aircraft-focused guide:
— Nexa Messerschmitt BF-109 1540mm ARF Review & Flying Notes
Safety & Charging
Charge LiPo with a balance charger on a fire-retardant surface. Store around 3.80V/cell. For LiFe receiver packs, use an appropriate chemistry mode and verify switch harness/servo current ratings before high-load maneuvers.